Switch Administration Guide
- Switch 1.2
- Product Overview
- Technical Specifications
- Supported SonicWall and 3rd party SFP and SFP+ Modules that can be used with SonicWall Switches
- Physical Interface - 10 Port Switch
- Physical Interface - 24 Port Switch
- Physical Interface - 48 Port Switch
- Physical Interface - 8 Port Switch
- Management Interface
- Connecting the Switch to a Network
- Web Access
- System Management
- System
- Switching
- Routing
- Security
- VLAN
- Logging
- Diagnostics
- System Maintenance
- Switch Troubleshooting
- SonicWall Support
Physical Interface - 10 Port Switch
- RJ45 Console Port
- Power LED: Light off = Power off; Solid Light = Power On.
- Fault LED: Light off = Normal Behavior; Solid Light = Error.
- PoE Max LED: Light off = Additional PoE device may still be added; Solid Light = The PoE device’s output power has exceeded total PoE limit. No additional devices can be powered on via PoE.
- LAN Mode LED: Light off = LAN mode is not activated; Solid Light = LAN mode is activated.
- PoE Mode LED: Light off = PoE mode is not activated; Solid Light = PoE mode is activated.
- LED Mode Selector: Press to change between LAN and PoE mode.
- Reset Button: Press to reset the device to factory default settings.
- RJ-45 LAN Ports: 10/100/1000 Mbps RJ-45 LAN ports.
-
LAN Mode LED (Per Copper Port): Light off = No link is established on the port; Solid Amber Light = A valid 100 Mpbs link is established on the port.
-
Link/Act LED (Per Copper Port): Light off = No link is established on the port; Solid Light = A valid link is established on the port; Blinking Light = Packet transmission on the port.
-
Speed LED (Per SFP Port). Solid Amber Light should be 10 Gbps Link, Solid Green Light should be 1 Gbps link.
- Link/Act LED (Per SFP Port).
-
SFP Ports: Small form factor pluggable ports: 1 or 10 Gbps ports.
- Power Connector.
Was This Article Helpful?
Help us to improve our support portal