Switch Administration Guide
- Switch 1.3.0
- Product Overview
- Package Contents
- Technical Specifications
- Supported SonicWall and third-party SFP and SFP+ Modules
- Physical Interface - 8 Port Switch
- Physical Interface - 10 Port Switch
- Physical Interface - 24 Port Switch
- Physical Interface - 48 Port Switch
- Device Management
- Connecting the Switch to a Network
- Capacity Matrix
- System Management
- System
- Switching
- Routing
- Security
- VLAN
- Logging
- Diagnostics
- System Maintenance
- Switch Troubleshooting
- SonicWall Support
IPv4-Based ACE
Allows IP Based Access Control Entry (ACE) to be defined within a configured ACL.
| ACL Name | Select the ACL from the list. |
| Sequence | Enter the sequence number which signifies the order of the specified ACL relative to other ACLs assigned to the selected inter- face. The valid range is from 1-2147483646, 1 being processed first. |
| Action |
Select what action to take if a packet matches the criteria.
|
| Protocol |
Select Any, Protocol ID, or Select from a List in the drop-down menu.
|
| Source IP Address | Select Any or User defined. |
| Source IP Address Value | Enter the source IP address. |
| Source IP Network Mask | Enter the mask of the new source IP address. |
| Destination IP Address | Select Any or User defined. |
| Destination IP Address Value | Enter the destination IP address. |
| Destination IP Network Mask | Enter the mask of the designation IP address. |
| ICMP |
Select Any, Protocol ID, or Select from the List in drop down menu.
|
| ICMP Code | Enter the ICMP code. The range is from 0-255. |
| Source Port | Select Single or Range from the list. Enter the source port that is matched to the packets. The range is from 0-65535. |
| Destination Port | Select Single or Range from the list Enter the destination port that is matched to the packets. The range is from 0-65535. |
| Type of Service | Enter the DSCP. The range is from 0-63. |
Click Apply to save the changes to the system.
After creating the MAC or IPv4ACL, bind it with a port by applying it in the Switch port settings. Select a port to edit, then navigate to the ACL binding section.
Was This Article Helpful?
Help us to improve our support portal