Switch Administration Guide
- Switch 1.3.0
- Product Overview
- Package Contents
- Technical Specifications
- Supported SonicWall and third-party SFP and SFP+ Modules
- Physical Interface - 8 Port Switch
- Physical Interface - 10 Port Switch
- Physical Interface - 24 Port Switch
- Physical Interface - 48 Port Switch
- Device Management
- Connecting the Switch to a Network
- Capacity Matrix
- System Management
- System
- Switching
- Routing
- Security
- VLAN
- Logging
- Diagnostics
- System Maintenance
- Switch Troubleshooting
- SonicWall Support
Alarm List
Configure Network alarms to occur when a network problem is detected. To add an alarm, click the Add button and select the alarm from the drop-down boxes.
|
Index |
Enter the entry number for the History Log Table. |
| Sample Stat | Select the port from which the alarm samples were taken. |
|
Sample Variable |
Select the variable of samples for the specified alarm sample. |
|
Sample Interval |
Enter the alarm interval time. |
|
Sample Type |
Select the sampling method for the selected variable and comparing the value against the thresholds.
|
|
Rise Threshold |
Enter the rising number that triggers the rising threshold alarm. |
|
Fall Threshold |
Enter the falling number that triggers the falling threshold alarm |
|
Rise Event |
Enter the event number by the falling alarm are reported. |
|
Fall Event |
Enter the event number by the falling alarms are reported. |
|
Owner |
Enter the Switch that defined the alarm. |
Was This Article Helpful?
Help us to improve our support portal