Network Security Manager On-Premises Administration Guide

Technical Documentation>  VPN Topology>  IPSec VPN Topology>  Topologies>  Adding a VPN Topology>  Basic Information
Table of Contents

Basic Information

To add basic information of a VPN topology

  1. Enter a Topology Name to identify.
  2. Enter a short description to identify the topology.

  3. Choose a Topology Type

    Hub and Spoke The network design where the central device is located.
    Full Mesh

    It provides a connection from each node to every other node on the network.
    Partial Mesh Some of the devices are connected to many devices together, but other devices are connected only to one or two devices. This option is disabled now.
    Point to Point

    This connects two nodes directly together with a common link.

  4. Select the IP Version.

    IPV4 32-Bit IP address which is numeric.
    IPV6

    128-Bit IP address which is alpha-numeric.

  5. Select the Policy Type.

    Site to Site Choose this option if there is a connection between two or more networks.
    Tunnel Interface Choose this option to create connection between peers and Virtual Tunnel Interfaces.