Secure Mobile Access 12.4 Administration Guide

Configuring Basic Network Settings Using the X0 Interface

You can connect your computer to the Ethernet port on your SMA appliance and use the Setup Wizard to configure your SMA appliance.

To configure basic network settings using the using the X0 Interface

  1. Configure your management computer with a static IP address on the same subnet as your internal (X0) interface. Set your computer to an IP address on the 192.168.0.0/24 subnet, such as 192.168.0.20, and set the subnet mask to 255.255.255.0 and the default gateway to 192.168.0.1.
  2. Using an Ethernet cable, connect your management computer to the X0 port on the SMA appliance.
  3. Access the wizard by starting a Web browser and typing: https://<IP address>:8443, where <IP address> matches the address you defined for the internal network interface. (The default X0 IP address is 192.168.0.10).
  4. Follow the instructions in the Setup Wizard to enter your configuration settings. (Refer to Web-Based Configuration Using Setup Wizard for instructions on using the Setup Wizard.)

Was This Article Helpful?

Help us to improve our support portal

Techdocs Article Helpful form

  • Hidden
  • Hidden

Techdocs Article NOT Helpful form

  • Still can't find what you're looking for? Try our knowledge base or ask our community for more help.
  • Hidden
  • Hidden