Configuring IGMP Snooping Settings

To edit an item in the 802.1Q list, and configure IGMP Snooping settings follow the below steps

1. Click the edit button in the row.
   
2. Click on the IGMP Snooping tab and select the required VLAN and Querier settings.

   

   Status	Enable or Disable IGMP Snooping
   Version	Select the operating version of the IGMP snooping Switch for a specific VLAN.
   Fast leave	Enable or disable Fast leave to remove the port information from a multicast group entry immediately after fast leave message is received.
   Querier State	Enable or Disable Querier State
   Interval	Enter the time interval at which the IGMP snooping queries are sent by the Switch when configured as querier on a VLAN. The value range is between 60 to 600 seconds.
   Max Response Interval	Enter the maximum response code inserted in general queries sent to host. The unit of the response code is tenth of second. This value ranges between 0 and 25.
   Startup Query Counter	Enter the maximum number of general query messages sent out on Switch startup when the Switch is configured as a querier. This value ranges between 2 and 5.
   Startup Query Interval	Enter the time interval between the IGMP snooping query messages sent by the Switch, during startup of the querier election process. This time interval ranges between 15 and 150 seconds and should be less than or equal to query interval divided by four.

3. Click Apply.