Configuring DHCPv6 Relay

To configure DHCPv6 Relay

1. Navigate to the NETWORK | System > IP Helper page.

2. Click the Policies view.
3. Click +Add. The Add IP Helper Policy dialog displays.

4. Select DHCPv6 from Protocol.
5. Select the desired interface from From.
6. In the To field, type in the destination IPv6 address. This can be a list of destination addresses, which might include unicast addresses, or other addresses you select. The address cannot be a multicast address.
7. If the destination in the To field is a:
   • Global address, there is no need to select an egress interface. Go to Step 8.
   • Link-local address, select an egress interface from Egress Interface.

8. Click Save.

• A new DHCP lease appears in the DHCPv6 Relay Leases section of the page when the client gets a new IP address from the server.