SonicOS 7 System

Technical Documentation>  Dynamic Routing>  OSPFv2
Table of Contents

OSPFv2

NETWORK | System > Dynamic Routing > OSPFv2, which displays only when Advanced Routing Mode is enabled on the Settings tab, shows the status of OSPFv2 and allows you to configure OSPFv2 for an interface.

Settings Icon from the top right portion of the page that displays the Settings pop-up for configuring the metrics for default routes. See General Settings.
Interface (Zone) Interfaces and their zone configured for OSPFv2. If a zone has not been configured for an interface, the (Zone) designation is (N/A).
OSPFv2

Indicates whether OSPF is enabled on an interface:

  • OSPF Enabled
  • OSPF Enabled (passive)
  • OSPF Disabled
OSPF Neighbor Status Displays the Status icon, which indicates whether there are active or inactive neighbors; clicking the icon displays the Interface OSPFv2 Area Neighbors pop-up for detail about the interface’s neighbors.
Configure Displays the Edit OSPFv2 Configuration icon for the interface.

Interface OSPFv2 Area Neighbors

Display this pop-up by clicking the Status icon for the interface. (OSPFv2 must be enabled on the Configuration dialog.)

Router-ID Neighbor’s router ID.
Current State

State of the OSPFv2 neighborhood when it is established:

  • Init
  • 2-way
  • ExStart
  • Exchange
  • Loading
  • Full
Priority Neighbor’s router’s priority.
IP Address IP address of neighbor’s router.