Wireless Network Manager Administration Guide
- Wireless Network Manager
- Getting Started with Wireless Network Manager
- Overview
- Using Air Marshal
- Managing Your Network
- Managing Policies
- Policy Hierarchy
- Select an AP Policy
- Select a Switch Policy
- General
- System
- Spanning Tree Protocol
- Link Layer Discovery Protocol
- Voice VLAN
- Quality of Service (QoS)
- Internet Group Management Protocol (IGMP) Snooping
- Dynamic Host Configuration Protocol (DHCP) Snooping
- Dynamic Host Configuration Protocol (DHCP) Relay
- Loopback Detection
- Jumbo Frames
- Multicast Filtering
- 802.1X
- Static Route IPV4
- DoS
- Radius Server
- Mirror Settings
- Address Resolution Protocol
- Static MAC Address Table
- SNMP
- Ports
- Link Aggregation
- VLAN
- Select an SSID
- Select a Security Policy
- AP Policies
- Using Tags to Manage Access Points and SSIDs
- QoS Policies
- Wi-Fi Multimeda (WMM) Profiles
- Managing Switch Policies
- Managing SNMP Policies
- Managing Switch SNMP Policies
- Policy Hierarchy
- Security
- Admin
- SonicWall Support
Creating Capture Advanced Threat Protection Security Policies
In order to take advantage of Capture Advanced Threat Protection (CATP or Capture ATP), create Capture ATP security policies as described below and select the categories of files you want to block. Once you have created a policy, apply it to an SSID group as explained in Applying a Security Policy to an SSID Group.
To create a Capture ATP security policy
- Navigate to Security > Security Policies.
- Click Add + to add a new security policy. The Add New Security Policy page displays.
- Enter the name of the policy.
-
From the Policy Type list, select CATP Security Policy.
-
Click Next. The Advanced page displays.
- In the General section, click Enable to enable the Capture ATP policy you have selected. Unselect it to disable the policy.
- Choose the Schedule from the drop-down list.
-
Click the Block Until Verdict to enable to decide whether questionable files should be allowed to pass.
If you are not concerned about their safety, you can allow them. If you do not want to take the chance of their being dangerous, select Block Until Verdict.
-
Optionally, you can set a Maximum File Size. The default maximum size is 10240 bytes. For SonicWave 231c/224w/231o models, the maximum size will reduce to 5120KB due to limited memory."
The following table shows the maximum size supported on the models:
Models Maximum size SonicWave231c/231o/224w 5,120 KB SonicWave432i/432e/432o 10,240 KB SonicWave621 1,024 KB SonicWave641/681 10,240 KB
- You can set the acceptable files types by checking any of the File Types boxes.
- Select the Protocol(s) as required.
- Specify the MD5 Exclusion List. For more information, refer to Adding an MD5 Hash to the Exclusion List.
- Click Save to save your selections.
The policy is now listed on the Security > Security Policies page.
Was This Article Helpful?
Help us to improve our support portal