Wireless Network Manager Administration Guide
- Wireless Network Manager
- Getting Started with Wireless Network Manager
- Overview
- Using Air Marshal
- Managing Your Network
- Managing Policies
- Policy Hierarchy
- Select an AP Policy
- Select a Switch Policy
- General
- System
- Spanning Tree Protocol
- Link Layer Discovery Protocol
- Voice VLAN
- Quality of Service (QoS)
- Internet Group Management Protocol (IGMP) Snooping
- Dynamic Host Configuration Protocol (DHCP) Snooping
- Dynamic Host Configuration Protocol (DHCP) Relay
- Loopback Detection
- Jumbo Frames
- Multicast Filtering
- 802.1X
- Static Route IPV4
- DoS
- Radius Server
- Mirror Settings
- Address Resolution Protocol
- Static MAC Address Table
- SNMP
- Ports
- Link Aggregation
- VLAN
- Select an SSID
- Select a Security Policy
- AP Policies
- Using Tags to Manage Access Points and SSIDs
- QoS Policies
- Wi-Fi Multimeda (WMM) Profiles
- Managing Switch Policies
- Managing SNMP Policies
- Managing Switch SNMP Policies
- Policy Hierarchy
- Security
- Admin
- SonicWall Support
Testing Connectivity With Your Gateway or DNS Addresses
You can test the connectivity of the SonicWave with your gateway or DNS addresses.
To test the connectivity of a SonicWave with your gateway or DNS addresses
- Navigate to the Network > Devices pages.
-
On the row for the device you want to test, hover over the far right area until the configuration icons appear.
The device must be online.
- Select the Diagnostics (Magnifier) icon. the Diagnose SonicWave page displays.
- Specify the Target (host name or IP address).
- In the Gateway, DNS Connectivity section, click Test next to the diagnostic test you want to run. The results will be displayed next to that Test button.
- Click Close to close the Diagnose SonicWave page.
Was This Article Helpful?
Help us to improve our support portal