Wireless Network Manager Administration Guide
- Wireless Network Manager
- Getting Started with Wireless Network Manager
- Overview
- Using Air Marshal
- Managing Your Network
- Managing Policies
- Policy Hierarchy
- Select an AP Policy
- Select a Switch Policy
- General
- System
- Spanning Tree Protocol
- Link Layer Discovery Protocol
- Voice VLAN
- Quality of Service (QoS)
- Internet Group Management Protocol (IGMP) Snooping
- Dynamic Host Configuration Protocol (DHCP) Snooping
- Dynamic Host Configuration Protocol (DHCP) Relay
- Loopback Detection
- Jumbo Frames
- Multicast Filtering
- 802.1X
- Static Route IPV4
- DoS
- Radius Server
- Mirror Settings
- Address Resolution Protocol
- Static MAC Address Table
- SNMP
- Ports
- Link Aggregation
- VLAN
- Select an SSID
- Select a Security Policy
- AP Policies
- Using Tags to Manage Access Points and SSIDs
- QoS Policies
- Wi-Fi Multimeda (WMM) Profiles
- Managing Switch Policies
- Managing SNMP Policies
- Managing Switch SNMP Policies
- Policy Hierarchy
- Security
- Admin
- SonicWall Support
Using Tags to Manage Access Points
Tags can be used to partition your wireless network into both physical, or security-based segments, and for basic management purposes.
- Adding Tags to an Access Point
- Removing Tags Associated with an Access Point
- Viewing Tags Associated with an Access Point
Was This Article Helpful?
Help us to improve our support portal