Wireless Network Manager Administration Guide
- Wireless Network Manager
- Getting Started with Wireless Network Manager
- Overview
- Using Air Marshal
- Managing Your Network
- Managing Policies
- Policy Hierarchy
- Select an AP Policy
- Select a Switch Policy
- General
- System
- Spanning Tree Protocol
- Link Layer Discovery Protocol
- Voice VLAN
- Quality of Service (QoS)
- Internet Group Management Protocol (IGMP) Snooping
- Dynamic Host Configuration Protocol (DHCP) Snooping
- Dynamic Host Configuration Protocol (DHCP) Relay
- Loopback Detection
- Jumbo Frames
- Multicast Filtering
- 802.1X
- Static Route IPV4
- DoS
- Radius Server
- Mirror Settings
- Address Resolution Protocol
- Static MAC Address Table
- SNMP
- Ports
- Link Aggregation
- VLAN
- Select an SSID
- Select a Security Policy
- AP Policies
- Using Tags to Manage Access Points and SSIDs
- QoS Policies
- Wi-Fi Multimeda (WMM) Profiles
- Managing Switch Policies
- Managing SNMP Policies
- Managing Switch SNMP Policies
- Policy Hierarchy
- Security
- Admin
- SonicWall Support
Adding Tags to an Access Point
To add a tag to an access point
- Navigate to Network > Devices.
- On the right of the access point for which you want to add a tag, click the Edit icon.
- The General tab is displayed by default.
-
On the Tags field, click on the Add Device Tag icon (+). and the Add Device Tag dialog displays.
- In the Device Tag field, enter the name for the tag you want to create.
- Click OK to save the tag.
- Click OK to save the configuration changes for the access point.
After adding a Device Tag, you can remove the tag if required by clicking the (x) pertaining to the tag.
Was This Article Helpful?
Help us to improve our support portal