Wireless Network Manager Administration Guide

Configuring NAT Mode for a DHCP IP Address

To configure NAT mode for a DHCP IP address

  1. Navigate to the Network > Devices page.
  2. Select Access Points.
  3. On the right of the device row, click Config/Edit. The Config SonicWave page displays.
  4. Click General
  5. Verify that the route mode is set to NAT.
  6. In the IP Address section, set the mode to DHCP.
  7. Click OK.

Was This Article Helpful?

Help us to improve our support portal

Techdocs Article Helpful form

  • Hidden
  • Hidden

Techdocs Article NOT Helpful form

  • Still can't find what you're looking for? Try our knowledge base or ask our community for more help.
  • Hidden
  • Hidden