Interface settings IPv6

You can configure IPv6 interface settings on the Network > System > Interfaces > Interfaces Settings > IPv6 page.

By default, all IPv6 interfaces appear as routed with no IP address. Multiple IPv6 addresses can be added on the

same interface. Auto IP assignment can only be configured on WAN interfaces.

PortShield interfaces are not supported in IPv6.

Each interface can be individually configured to either receive or ignore router advertisements. According to your requirements, IPv6 can be enabled or disabled on each interface.

The zone assignment for an interface must be configured through the IPv4 interface page before switching to IPv6 mode.

 

• IPv6 Interface Configuration Constraints

• Configuring IPv6 Tunnel Interfaces

• Configuring an Interface for IPv6 Static Mode

• Configuring Advanced IPv6 Interface Options and Multiple IPv6 Addresses

• Configuring Router Advertisement Settings

• Configuring Router Advertisement Prefix Settings

• Configuring an Interface for DHCPv6 Mode

• Viewing DHCPv6 Protocol Information

• Configuring an Interface for Auto Mode

• Configuring a VLAN Sub-Interface in IPv6

• Configuring an Interface for Wire Mode in IPv6