SonicOS 7.0 Access Points
- SonicOS7.0
- About Access Points
- Settings
- Synchronize Access Points
- Provisioning Overview
- Creating/Modifying Provisioning Profiles
- Adding/Editing a Provisioning Profile - Getting Started
- General Settings for Provisioning Profiles
- 5GHz/2.4GHz Radio Basic Settings for Provisioning Profiles
- 5GHz/2.4GHz Radio Advanced Settings for Provisioning Profiles
- Sensor Settings for WIDP in Provisioning Profiles
- Mesh Network Settings for Provisioning Profiles
- 3G/4G/LTE WWAN Settings for Provisioning Profiles
- Bluetooth LE Settings for Provisioning Profiles
- Deleting Access Point Profiles
- Product Specific Configuration Notes
- Managing Access Point Objects
- Firmware Management
- Floor Plan View
- Station Status
- Intrusion Detection Services
- Advanced IDP
- Packet Capture
- Virtual Access Points
- RF Monitoring
- RF Analysis
- RF Spectrum
- FairNet
- Wi-Fi Multimedia
- 3G/4G/LTE WWAN
- Bluetooth LE Devices
- Radio Management
- SonicWall Support
Set Measuring Scale
You can set a measuring scale to show the relationship of real distance (feet) and the pixels that make up the picture of the floor plan. You can use this value to help estimate the RF coverage.
To set the measuring scale
- Navigate to DEVICE | Access Points > Floor Plan View page.
- Hover on the (Measure distance and areas) icon on the left bottom of the page and click create a new measurement option.
- Start creating a measurement by adding points to the map and click Finish measurement.
Was This Article Helpful?
Help us to improve our support portal