SonicOS 7.0 Access Points
- SonicOS7.0
- About Access Points
- Settings
- Synchronize Access Points
- Provisioning Overview
- Creating/Modifying Provisioning Profiles
- Adding/Editing a Provisioning Profile - Getting Started
- General Settings for Provisioning Profiles
- 5GHz/2.4GHz Radio Basic Settings for Provisioning Profiles
- 5GHz/2.4GHz Radio Advanced Settings for Provisioning Profiles
- Sensor Settings for WIDP in Provisioning Profiles
- Mesh Network Settings for Provisioning Profiles
- 3G/4G/LTE WWAN Settings for Provisioning Profiles
- Bluetooth LE Settings for Provisioning Profiles
- Deleting Access Point Profiles
- Product Specific Configuration Notes
- Managing Access Point Objects
- Firmware Management
- Floor Plan View
- Station Status
- Intrusion Detection Services
- Advanced IDP
- Packet Capture
- Virtual Access Points
- RF Monitoring
- RF Analysis
- RF Spectrum
- FairNet
- Wi-Fi Multimedia
- 3G/4G/LTE WWAN
- Bluetooth LE Devices
- Radio Management
- SonicWall Support
Creating a Floor Plan
There are several ways you can create a new Floor Plan.
The first method of creating a new floor plan
- Navigate to DEVICE | Access Points > Floor Plan View page.
- Click the (Floorplan List) icon in the upper right corner. The Floorplans dialog appears.
-
Click the + icon in the right corner. Another Floorplans dialog is displayed.
-
Fill in the fields describing the plan.
-
Click OK.
A second method of adding a new Floorplan
-
Navigate to DEVICE | Access Points > Floor Plan View page.
-
Click + Create Floorplan in the upper right corner. The Add New Floorplan dialog appears.
-
Fill in the fields describing the plan.
-
Click OK.
The third method of creating a new Floorplan is as follows
-
Navigate to DEVICE | Access Points > Floor Plan View page.
-
Click +Add New in the middle area of the page. The Add New Floorplan dialog appears.
-
Fill in the fields describing the plan.
-
Click OK.
Was This Article Helpful?
Help us to improve our support portal