SonicOS 7.0 Access Points

Technical Documentation> Virtual Access Points> Virtual Access Point Profiles> IEEE802.11K Settings

SonicOS7.0
About Access Points
Settings
Firmware Management
Floor Plan View
- Managing the Floor Plans
- Managing Access Points
Station Status
Intrusion Detection Services
- Scanning Access Points
- Authorizing Access Points
Advanced IDP
Packet Capture
Virtual Access Points
RF Monitoring
RF Analysis
- Using RF Analysis on SonicWall Access Points
RF Spectrum
FairNet
Wi-Fi Multimedia
3G/4G/LTE WWAN
Bluetooth LE Devices
- Viewing BLE Scanned Data
Radio Management
- Configuring Radio Management
- Configuring Dynamic Channel Selection Settings
SonicWall Support
- About This Document

IEEE802.11K Settings

IEEE802.11k settings are only supported on SonicWave products. These settings take no effect when the VAP is bound to an earlier generation SonicPointN/AC. Under IEEE802.11k Settings, select Neighbor Report to enable the collection of information about neighboring access points. This option is not selected by default.

< Prev Section

Next Section >

SonicOS 7.0 Access Points

Table of Contents

IEEE802.11K Settings