Pass EIGRP traffic through an L2 Bridge pair
03/26/2020 9 People found this article helpful 453,164 Views
Description
Pass EIGRP traffic through an L2 Bridge pair
Resolution
Perform the following steps to pass EIGRP traffic through an Layer 2 Bridge pair. This article assumes the Layer 2 Bridge pair is between LAN and WAN interfaces.
Enable the Enable Multicast Support check box under LAN and WAN interfaces.
Enable the
Enable Multicast checkbox under
Firewall Settings |
Multicast page.
Disable the
Require IGMP Membership reports for multicast data forwarding check box.
Select radio button
Enable reception of all multicast addresses
Click on
Accept to save the changes.
Navigate to the
Firewall |
Access Rules page.
Navigate to the
WAN to
Multicast page.
Create the following access rule to allow all traffic:
By default, all traffic from LAN to Multicast is allowed via the following access rule.
Related Articles
Categories
Was This Article Helpful?
YESNO