Switch 1.1 Release Notes
Version 1.1.0.1
August 2021
Compatibility and Installation Notes
The SonicWall Switch 1.1.0.1 release is supported on all SonicWall Switch platforms:
- SWS12-8
- SWS12-8POE
- SWS12-10FPOE
- SWS14-24
- SWS14-24FPOE
- SWS14-48
- SWS14-48FPOE
For information about obtaining the latest Switch firmware and upgrading the firmware image on your SonicWall Switch, see the Switch Getting Started Guide available on the Support portal at: Switch Getting Started Guide.
Resolved Issues
| Issue ID | Issue Description |
|---|---|
| SWO-1581 | Port Description on Standalone Switch management interface. |
| SWO-1568 | Unable to edit/delete static route on Standalone Switch management interface when next hop address is not reachable from the Switch. |
| SWO-1539 | Deleting VLAN throws error : "Unable to edit VLAN entry" |
| SWO-1486 |
User unable to create VLAN from standalone Switch management interface. |
| SWO-1293 |
User defined MAC ACE not working in some cases. |
| SWO-1274 |
User able to create IPv4 ACE with Invalid IP subnet_mask from standalone Switch management interface. |
| SWO-1094 |
During some corner cases, Switch console shows error and then gets stuck. Powercycling the Switch recovers the console access. |
| SWO-934 |
QoS Policy map is not displaying an option in Switch management interface to take an action based on classified traffic. |
| SWO-927 |
When wrong data entered while creating a class-map proper error is not shown. |
| SWO-789 |
Normal user can view all screens similar to a user with admin rights. |
| SWO-466 | Switchports should always be part of default VLAN 1 or any custom VLAN. |
Known Issues
| Issue ID | Issue Description |
|---|---|
| SWO-1604 | Web session timeout is not a configurable field. |
| SWO-1587 |
This is an intermittent issue, When upgraded to 1.1.0.1-13s Switch doesn't get auto rebooted. Workaround: once after observing this issue, Switch upgraded to 1.1.0.1-13 successful by performing manual reboot via Switch CLI / UI or Power Cycle. |
| SWO-1574 | Jumbo Frames are not working as expected when speed and duplex is set to 100Mbps/Full. |
| SWO-1569 | SonicWall Switch fails to dynamically update the Switch host or Switch network ARP entries in ARP table. |
| SWO-1553 | When any configuration change is done on a Switch port with 802.1X enabled, error is displayed. |
| SWO-1497 |
Switch fails to complete 802.1x authentication when using with EAP-TLS protocol. Workaround: We can use PEAP, CHAP. |
| SWO-1452 | SNMP related settings are not available on Switch. |
| SWO-1443 | Users are not able to differentiate mandatory and non-mandatory field while creating MAC or IPv4 based ACE's on Standalone Switch management interface. |
| SWO-764 | Unable to download/export Switch logs from Standalone Switch management interface. |
Was This Article Helpful?
Help us to improve our support portal