Secure Mobile Access 10.2 User Guide

Configuring NetExtender Packet Capture Properties

Within the NetExtender Properties dialog box, click the Packet Capture heading in the menu on the left panel. The available options allow you to enable and disable packet capture and data compression on NetExtender.

You must have Administrator privileges to change packet capture settings.

To configure packet capture

  1. To enable packet capture, select Enable NetExtender packet capture.
  2. If packet capture is enabled, clear all captured packet data when NetExtender exits by selecting Clear the capture when NetExtender exits. To disable packet capture, clear this check box.
  3. If packet capture is enabled, clear all captured packet data when NetExtender exits by selecting Clear the capture when NetExtender exits. To retain packet data, clear this check box.
  4. To enable data compression of captured packets, select Enable data compression. To disable data compression the next time NetExtender is connected, clear this box. If packet capture is enabled when NetExtender connects and you want to disable data compression immediately (instead of waiting until the next time NetExtender is connected), select Attempt to disable data compression during packet capture.
  5. Click Apply to save your changes.

Was This Article Helpful?

Help us to improve our support portal

Techdocs Article Helpful form

Techdocs Article NOT Helpful form

  • Still can't find what you're looking for? Try our knowledge base or ask our community for more help.