This command enables/disables Power Over Ethernet on the specified port to provide power over a copper Ethernet cable to an endpoint or powered device.

power inline { enable | disable }

This command limits Power Over Ethernet on the specified port to provide power over a copper Ethernet cable to an endpoint or powered device.

power inline limit { auto | <short(1-30)> }

• auto - automatically and allocates power to the PoE port after device detection, if enough power is available.

• <short(1-30)> - The maximum wattage feature limits the power allocated on the port. This value ranges between 1 and 30 watts.

This command sets the priority of the Power Over Ethernet on the specified port.

power inline priority { critical | high | low }

• critical - Sets the Power Over Ethernet port priority to critical

• high - Sets the Power Over Ethernet port priority to high

• low - Sets the Power Over Ethernet port priority to low

This command displays the Power Over Ethernet power supply status information such as PoE Global admin state, PSE operational status and Maximum power supply.

show power detail

This command displays the Power Over Ethernet power supply status information of each Power Sourcing Equipment.

show power inline [{<interface-type> <interface-id>}]

• <interface-type> - Displays the information about the specified type of interface. The interface can be:

  • gigabitethernet - A version of LAN standard architecture that supports data transfer upto 1 Gigabit per second.

• <interface-id> - Displays the information about the specified interface identifier. This is a unique value that represents the specific interface. This value is a combination of slot number and port number separated by a slash. For Example: 0/1 represents that the slot number is 0 and port number is 1.