SonicOSX 7 Rules and Policies
- SonicOSX 7 Rules and Policies
- Settings
- Security Policy
- NAT Policy
- About NAT in SonicOSX
- About NAT Load Balancing
- About NAT64
- About FQDN-based NAT
- About Source MAC Address Override
- Viewing NAT Policy Entries
- Adding or Editing NAT or NAT64 Policies
- Deleting NAT Policies
- Creating NAT Rule Policies: Examples
- Creating a One-to-One NAT Policy for Inbound Traffic
- Creating a One-to-One NAT Policy for Outbound Traffic
- Inbound Port Address Translation via One-to-One NAT Policy
- Inbound Port Address Translation via WAN IP Address
- Creating a Many-to-One NAT Policy
- Creating a Many-to-Many NAT Policy
- Creating a One-to-Many NAT Load Balancing Policy
- Creating a NAT Load Balancing Policy for Two Web Servers
- Creating a WAN-to-WAN Security Policy for a NAT64
- DNS Doctoring
- Routing Rules
- Decryption Policy
- DoS Policy
- Endpoint Policy
- Shadow
- SonicWall Support
Setting up the Decryption Policy Table
To configure the Decryption Policy table
-
Navigate to POLICY | Rules and Policies > Decryption Policy.
The Decryption Policy table displays.
-
Define the Grid Settings by clicking Grid Settings in the upper right corner. The Grid Settings dialog displays.
You can modify the order of the columns within a group adjust the order of the Group columns, and add new columns depending on your requirements.
-
In the Column Selection tab, click the arrows on the left to show column options that you can choose to help display Decryption Policy data.
-
Click the Preferences tab for additional options for setting up the appearance of your table.
- Click Apply after selecting the desired options to save your configuration.
Was This Article Helpful?
Help us to improve our support portal