Secure Mobile Access 100 10.2 Administration Guide

Configuring Network Interfaces

The IP settings and interface settings of the SMA appliance can be configured by clicking on the blue arrow in the corner of the Network Interfaces section of the System > Status page. The link redirects you to the Network > Interfaces page that can also be accessed from the navigation bar. From the Network > Interfaces page, a SMA appliance administrator can configure the IP address of the primary (X0) interface, and optionally configure additional interfaces for operation.

For a port on your SMA appliance to communicate with a firewall or target device on the same network, you need to assign an IP address and a subnet mask to the interface.

Was This Article Helpful?

Help us to improve our support portal

Techdocs Article Helpful form

Techdocs Article NOT Helpful form

  • Still can't find what you're looking for? Try our knowledge base or ask our community for more help.