SonicOS/X 7 Capture ATP

Basic Setup Checklist

The Basic Setup Checklist:

  • Displays the status of Capture ATP and its components, Gateway Anti-Virus and Cloud Gateway Anti-Virus.
  • Displays any error states that might be present.
  • Allows enabling or disabling of the Capture ATP service.
  • Provides links to the POLICY | Security Services > Gateway Anti-Virus page for the GAV, Cloud Gateway Anti-Virus, and protocol inspection settings.
  • Displays a matrix of the protocol inspection settings and whether the inbound and outbound directions have been enabled.

For messages that display in this section, see the Capture ATP Status through Protocols Inspection Settings tables. Enabled corresponds to a green checkmark, and Disabled corresponds to a red X.

Capture ATP Status
Icon Message Link Action
Enabled Capture ATP service is enabled until renewal_date. disable it Click the link to turn off Capture ATP and put the service in disabled mode. You do not need to click Accept to apply this change.
Disabled Capture ATP subscription is valid until renewal_date but the service is not currently enabled. enable it Click the link to turn on Capture ATP and put the service in enabled mode. You do not need to click Accept to apply this change.
Disabled Capture ATP subscription expired on renewal_date. renew it Click the link to go to MySonicWall to renew the service.
Gateway Anti-Virus Status
Icon Message Link Action
Enabled Gateway Anti-Virus is Enabled. manage settings Click the link to display the POLICY | Security Services > Gateway Anti-Virus page.
Disabled You must enable Gateway Anti-Virus for Capture ATP to function. manage settings Click the link to display the POLICY | Security Services > Gateway Anti-Virus page.
Cloud Gateway Anti-Virus Database Status
Icon Message Link Action
Enabled Cloud Gateway Anti-Virus Database is enabled. manage settings Click the link to display the POLICY | Security Services > Gateway Anti-Virus page.
Disabled You must enable the Cloud Gateway Anti-Virus Database for Capture ATP to function. manage settings Click the link to display the POLICY | Security Services > Gateway Anti-Virus page.

The Inspected Protocols table also provides a manage settings link that takes you to the POLICY | Security Services > Gateway Anti-Virus page. There, you can enable or disable inspection of specific network traffic protocols, including HTTP, FTP, IMAP, SMTP, POP, CIFS, and TCP Stream. Each protocol can be managed separately for inbound and outbound traffic.

The table that follows Inspected Protocols displays the current inspection settings for each protocol, in each direction; see Protocols Inspection Settings.

Protocols Inspection Settings
Icon Message
Enabled Protocol is inspected.
Disabled Protocol is not inspected.
n/a Inspection is not applicable to this protocol in this direction.

Was This Article Helpful?

Help us to improve our support portal

Techdocs Article Helpful form

Techdocs Article NOT Helpful form

  • Still can't find what you're looking for? Try our knowledge base or ask our community for more help.