• Secure Mobile Access 10.2
• Introduction
• Before You Begin
  • Supported Platforms
  • Creating a MySonicWall Account
• Installing the SMA 500v for AWS Virtual Appliance
  • Installing SMA 500v for AWS
• Configuring the SMA 500v for AWS Virtual Appliance
  • Powering the Virtual Appliance On or Off
  • Connecting to the Web Interface
  • Connecting to the Command Line Interface
  • Using the Command Line Interface
    • Reboot
    • Restart SSL VPN Services
    • Logout
    • Save TSR to Flash
    • Display EULA
  • Configuring Settings on the Appliance Web Interface
• Licensing and Registering Your Appliance
  • Registering the SMA 500v for AWS
  • De-registering an SMA 500v for AWS
• Using the 30-day Trial Version
  • Deployment Considerations
  • Registering the 30-day Trial Virtual
  • Converting a Free Trial License to Full
• Upgrading Your Appliance
  • Obtaining the Latest Image Version
  • Exporting a Copy of Your Configuration
  • Uploading a New Image
• SonicWall Support
  • About This Document

Configuring NetExtender Packet Capture Properties

Within the NetExtender Properties dialog box, click the Packet Capture heading in the menu on the left panel. The available options allow you to enable and disable packet capture and data compression on NetExtender.

You must have Administrator privileges to change packet capture settings.

To configure packet capture

1. To enable packet capture, select Enable NetExtender packet capture.
2. If packet capture is enabled, clear all captured packet data when NetExtender exits by selecting Clear the capture when NetExtender exits. To disable packet capture, clear this check box.
3. If packet capture is enabled, clear all captured packet data when NetExtender exits by selecting Clear the capture when NetExtender exits. To retain packet data, clear this check box.
4. To enable data compression of captured packets, select Enable data compression. To disable data compression the next time NetExtender is connected, clear this box. If packet capture is enabled when NetExtender connects and you want to disable data compression immediately (instead of waiting until the next time NetExtender is connected), select Attempt to disable data compression during packet capture.
5. Click Apply to save your changes.