Secure Mobile Access 100 10.2 Administration Guide

NetGear FVS318

This guide assumes that your NetGear FVS318 Gateway is configured with an IP of 192.168.100.1 and your SMA appliance is configured with an IP of 192.168.100.2.

  1. Click Remote Management from the left index of your Netgear management interface.

    For the SMA appliance to function with your Netgear gateway device, you must verify that the NetGear’s management port does not conflict with the management port used by the SMA appliance.

  2. Clear the Allow Remote Management box.
  3. Click Accept to save changes.

    If Remote Management of the NetGear is desired, you must leave the box checked and change the default port (8080 is recommended)

  4. Navigate to Add Service in the left navigation.
  5. Click Add Custom Service.
  6. To create a service definition, enter the following information:

    NameHTTPS
    TypeTCP/UDP
    Start Port443
    Finish Port443
  7. Navigate to Ports in the left navigation. Click Add.

  8. Select HTTPS from the Service Name drop-down menu.
  9. Select ALLOW always in the Action drop-down menu.
  10. Enter the WAN IP address of the SMA appliance (ex.192.168.100.2) in the Local Server Address field.
  11. Click Accept to save changes.

    Your NetGear gateway device is now ready for operations with the SMA appliance.

Was This Article Helpful?

Help us to improve our support portal

Techdocs Article Helpful form

Techdocs Article NOT Helpful form

  • Still can't find what you're looking for? Try our knowledge base or ask our community for more help.