Secure Mobile Access 100 10.2 Administration Guide

Linksys WRT54GS

The SMA appliance should be configured on the LAN switch of the Linksys wireless router. This guide assumes that your Linksys is assigned a single WAN IP, through DHCP by the cable ISP and is using the default LAN IP address scheme of 192.168.1.0/24.

Version 2.07.1 firmware or newer is recommended for this setup.

To configure your Linksys for operation with the SMA appliance, you must forward the SSL (443) port to the IP address of the SMA appliance

  1. Log in to the Linksys device.
  2. Navigate to the Applications & Gaming tab.

  3. Enter the following information:

    Information to be added to Applications & Gaming Tab
    ApplicationSMAThe name for the port forwarded application.
    Port Range Start443The starting port number used by the application.
    Port Range End443The ending port number used by the application.
    ProtocolTCPThe SMA application uses TCP.
    IP Address192.168.1.10The IP address assigned to the SMA appliance.
    EnableCheckedSelect the check box to enable the SSL port forwarding.
  4. With the configuration complete, click Save Settings at the bottom of the page.

    The Linksys is now ready for operations with the SMA appliance.

Was This Article Helpful?

Help us to improve our support portal

Techdocs Article Helpful form

Techdocs Article NOT Helpful form

  • Still can't find what you're looking for? Try our knowledge base or ask our community for more help.