How to change the IP address of the appliance, if you cannot access webUI and cannot get to CLI

03/26/2020 19 People found this article helpful 485,909 Views

Description

Question:

Answer:

Connect a monitor and a ps2 keyboard to the appliance.
Reboot the appliance.
Device will boot up and prompt you for login.
Please login with your WebUI admin username and password.
You will get SNWLCLI:> Prompt
at the Prompt type the following to check the IP on the device.
SNWLCLI:>interface (Hit the Enter key to see results)
Now type the following command to change the IP to the new IP using the following snytax
SNWLCLI:> interface eth0 192.168.50.5 255.255.255.0 ( Hit Enter) ( this is the new IP and new subnet mask)
SNWLCLI:>

It will come back to the prompt after changing the IP, to verify the IP has been changed you can run the "interface" command again from CLI prompt.

Not Finding Your Answers?

ASK THE COMMUNITY

Was This Article Helpful?

YES NO

How to change the IP address of the appliance, if you cannot access webUI and cannot get to CLI

Description

Related Articles

Categories

Not Finding Your Answers?

Was This Article Helpful?

Article Helpful Form

Article Not Helpful Form

Follow Us

Subscribe to newsletter

Stay In Touch