How to check GMS disk performance in Virtual Appliance?

1. Connect to the GMS using 'Putty'

2. Use the following command to verify disk performance:

[root@snwl GMSVP]# dd if=/dev/zero of=/opt/GMSVP/Temp/100M.tst bs=100M count=1
1+0 records in
1+0 records out
104857600 bytes (100.0MB) copied, 0.565954 seconds, 176.7MB/s

From the above, we can see to write 100MB data to the Temp folder (opt/GMSVP/Temp) it took 0.565954 seconds with a  throughput of 176.MB/s

There are no set limit to verify which system is the fastest or slowest. Each depends on client needs. But somewhere below 100MB/s can be consider as low performance disk. We can recommend client to consider replacing the disk at their earliest convenient time.