How to Start and Stop SonicWall Endpoint Security

Description

This article explains how to troubleshoot issues where SonicWall Endpoint Security (SES) is suspected to be causing a problem. It covers the steps to verify whether SES is contributing to the issue, how to temporarily bypass or disable SES components for testing purposes, and how to collect the necessary logs and diagnostic information for further analysis. The goal is to isolate the issue and determine whether it is related to SES or another application, service, or system component.

Resolution

  1. Disable Anti-Tamper Protection from the SES console.

  2. To stop the SES service, open Command Prompt as Administrator and run the following command:

 

sc control theronsvc 255

 

  1. To start the SES service again, open Command Prompt as Administrator and run:

 

sc start theronsvc

 

  1. Verify that the Theron SVC service is running and that the endpoint status is updated correctly in the SES console after restarting the service.
  2. enable the Anti-temper 

 

Related Articles

  • SonicWall Endpoint Security (SES) - Getting Started Prerequisites
    Read More
  • SonicWall Endpoint Security (SES) seed deployment assistance guide
    Read More
  • How to Download and Install the SonicWall Endpoint Security (SES) Agent
    Read More
not finding your answers?